When I need to rout small narrow stock, I use the subbase shown here for added stability. The base is a piece of hardboard with two wooden clamp- blocks fastened to one edge. I made a hardwood rail with a pair of 5/16"-diameter bolts epoxied into holes in the rail. These bolts slide up and down in the jig's wooden clamps to compensate for different workpiece thicknesses. A bolt passes through each clamp, and a wingnut locks it in place.

Once you've fastened the jig to the router, it's easy to use. Set the edge of the jig on your workpiece and move the rail down to rest on the bench surface. Check to make sure the jig base is flat on the workpiece, and tighten the wingnuts. With the jig set and locked, the rail prevents the router from tipping, just like the outrigger on a boat. I attach small workpieces to the bench temporarily with double-sided tape to hold them while I rout the edges. Using this outrigger jig, routing small workpieces is smooth sailing.

- Frank Penicka; Mount Pearl, Newfoundland

Click Here to Return to the Top of the Page
Related Articles - Store Lock Out Keys in Back of Drawer - Handy, Inexpensive Sawdust Collector - Expanding Your Shop Space - Drill Press Support - Bungee Keeps Electrical Cord Out of Harm's Way - Try Trays for Better Organization - Store Dowels in Staggered Lengths of Drain Pipe - Old Bar Stool Aids in Spray-Finishing - Shop Made Hold-Downs - Jig Simplifies Cutting Arcs on a Router Table	Advertisement