Tricks to keep lumber safely tight to a machine while cutting or routing are always helpful. Here are a couple of ideas I find useful:

1. Simply slice a piece of 3/4” plywood with a thin saw kerf cut at about a 30 degree angle. A flexible blade putty knife is then secured in the kerf, and the unit is clamped on the table saw's rip fence at the desired height.

2. This is also a piece of 3/4” plywood with kerfs long enough to hold wooden slats about the thickness of paint stirring paddles. I bevel the bottom edge for better contact with the wood. The slats are slid into the kerf, then glued and tacked into place. This hold-down can be made any length or width needed. Longer models are great for controlling really long pieces as they're being ripped on a table saw.

-R.B. Himes, Vienna, Ohio

Click Here to Return to the Top of the Page
Related Articles - Vinyl Blind Lamination Spacers - Handy Push Sticks - Keep Your Pockets Clean While Turning - Fixing Errors in Plastic - Color Coding Bits - Cleaning Pocket Hole Joinery - Simple Shop Divider - Small Item Storage - A New Laminate Spacer - Sanding Disk Alignment	Advertisement