Comments on: Close-Up Look at Bosch Glide Miter Saw

By: Don Jusiak

Don Jusiak — Wed, 13 Oct 2010 22:24:25 +0000

Preordered in September and received it on October 10.

The only setup was to insert and tighten the miter lock knob and install the bevel lock lever.

After familiarizing myself with the saw, and making no adjustment to the miter or bevel I cut a 5-inch wide x 3/4″ board and checked each for square. I then set the miter for a 45-degree cut and, again, the angle was perfect.

I can honestly say the bevel and miter were 100% square right out of the box.

The glide movement is not set at the factory, and the movement is very smooth. This is a personal preference and the adjustment is to simply tighten or loosen two set screws.

By: Chris Marshall

Chris Marshall — Fri, 27 Aug 2010 01:24:54 +0000

John,

The Glide Miter Saw’s dust port accepts standard 1 1/4″ or 35mm DC vac hose nozzles.

By: John Gray

John Gray — Thu, 26 Aug 2010 18:23:57 +0000

Please find out more about the dust collection on the saw. As in what DC fittings come on the saw, also get them to cut the exact same piece, on camera, with DC turned on and off.

By: Kenny R.

Kenny R. — Thu, 26 Aug 2010 02:29:16 +0000

From the factory what is the accuracy? Will you have to readjust?