Redwood & Mulberry Hanger

In addition to putting reclaimed lumber to good use, this reader-submitted project includes a handy tip for routing a profile on a uniquely-shaped piece of wood.

I made this last week. It’s about 18-1/2″ long. The back is redwood. The hooks are made from mulberry the city cleared from over the street and tossed in the woods here in my neighborhood. Satin poly finish on the redwood and spray laquer on the mulberry. Interestingly, the logs sitting on the concrete floor in my garage tried sprouting new stems and leaves for 5 months. Three years on it seems to have stopped.

Routing the profile on the dog-ear corners gave me cause to ponder. At only 5/16″ thick, I didn’t have a place for the guide bearing to ride and still get the profile I wanted from the bit I have. But on the router table, how would I keep the piece steady with only an inch or so against the fence? In the end I cut some scrap MDF at 45 degrees and used that as a push block against the fence and just held the two together and slid it past the bit. It worked so well I’m keeping the MDF stored under the router table.

- Dean Morrell

Do you have a project you’d like to share? Click here to send it in!

Matt Becker
Internet Production Coordinator

hanger 2

hanger 1

Related posts:

 

One thought on “Redwood & Mulberry Hanger

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>