Posts Tagged ‘Table Saw’

December Issue Sneak Peek

October 26th, 2009 by
Leave A Comment »
BENCH DOG

Bill Hylton surveys two full-featured router tables in Today's Shop.

There’s a December issue of Woodworker’s Journal headed to your mailbox soon, and this issue is dedicated to one of our all-time favorite tools: the router. Here’s the inside scoop on what you’ll find.


Whiz-bang Router Tables: Bill Hylton takes a close look at two of the industry’s “top-shelf” router tables in “Today’s Shop,” and he discusses how installing a router in a table can help you take new “routes” in your woodworking projects. If you’d rather build your own router table, Sandor Nagyszalanczy has designed a versatile horizontal router table, and we’ll provide the measured drawings and step-by-steps so you can build one for your shop.

(more…)

Angling Without the Snags

September 28th, 2009 by
2 Comments »
Sutherland Tools Bevel Boss takes all the guesswork out of setting accurate cutting angles.

Sutherland Tools Bevel Boss takes all the guesswork out of setting accurate cutting angles.

About six years ago, I was building some outdoor furniture with lots of angles to them, and the closest thing I had to an angle-setting device was my speed square. No offense to you hard-core carpenters out there, but frankly, a speed square seems better suited to rafter tails than woodworking.

I always felt like I was plus or minus a few degrees on my cuts, which just wasn’t cutting it, so to speak. I needed something more accurate that I could really trust.

(more…)

Stick with What Works

August 19th, 2009 by
2 Comments »

Some might call this tedious work, but repetition is part of what I enjoy about mortising.

Some might call this tedious work, but repetition is part of what I enjoy about mortising.

A couple years ago, I invested in a popular loose-tenon joinery system to see how that would work for me. As a tool reviewer, I’m always anxious to try a new gizmo on for size, and this tool was getting a lot of buzz. Heck, a faster, easier way to make mortise-and-tenon joinery. Sounded good to me!

Well, the product came, and I put it to work on my next few projects. It did the job swimmingly, chomping mortise after mortise in good time. The cuts were clean, the setup was pretty easy and those loose tenons dropped right into place. Really, there was no part of the operation I could complain about.

But as time went on, that new tool got less use than it first did. I ended up switching back to making M&Ts the way I’ve always done them: mortising on the drill press, followed by tenon-cutting on the table saw.

Why?

(more…)

Three-dollar Fix Improves Fold-Down Outfeed Table

July 24th, 2009 by
2 Comments »

Your feedback can help make a good project even better, so tell us what you think. We'll appreciate it.

Douglas Green's modification to the "Fold-down Outfeed Table" makes it a better project. Thanks for the great tip, Doug!

Earlier this spring we received some good feedback about the “Fold-down Outfeed Table” project that ran in the February 2009 issue (p. 50). Glad you folks like it! But, if you’re planning to build one for your table saw (or if you’ve already completed it), be sure to add a simple modification sent in by fellow reader Doug Green from Wellington, Colorado. Doug installed a couple of screw eyes and a wire cable between the bottom of the table and the leg to keep the leg from swinging free when setting the table up. In case you missed it, he sent in a few photos of his version of the project, and they appear on p. 12 of the June 2009 print issue in “Letters.”

(more…)