Arthritis Won't Stop This Woodworker!
I've been a custom woodworker on and off for 40 years and recently, arthritis in my hands has made it more difficult to get some shop tasks done. Tightening clamps is particularly painful, especially if I'm doing a big glue-up with 30 or more clamps. Even so, arthritis is not going to stop me from woodworking, and I've got a great clamp modification to share.
Just drill a pilot hole in the end of the clamp handle and drive in a lag screw. I use epoxy to make sure the screw won't ever back out. With a hex head on the clamp handle, you can use a wrench, ratchet or even an air ratchet to tighten and loosen it without pain.
- Ray Johnson; Blue Ridge, Georgia
This article originally appeared in the Woodworker's Journal eZine.
Click here for information on this free, twice monthly online publication.
Copyright; 2010 Woodworker's Journal
All rights reserved. No part of this article may be reproduced in any form or by any electronic or mechanical means, including information storage and retrieval devices or systems, without prior written permission from the publisher.