To gauge the accuracy of my cylinder turnings, I built a homemade jig that's easier to use than calipers. My jig (shown at left) is a 1/4" thick plywood panel with lines spaced 1" apart and parallel to the lathe bed. While turning, I simply sight over the top edge of my workpiece to compare its shape with the lines, which reveals any high or low spots immediately. My jig hooks in place on the lathe bed, but there's enough clearance for the tool-rest to move freely. The jig also provides an ideal place to hang a story stick or turning diagram.
- Dick Dorn, Oelwein, Iowa
This article originally appeared in the Woodworker's Journal eZine.
Click here for information on this free, twice monthly online publication.
Copyright; 2010 Woodworker's Journal
All rights reserved. No part of this article may be reproduced in any form or by any electronic or mechanical means, including information storage and retrieval devices or systems, without prior written permission from the publisher.