The new T-Track Stops from Rockler Woodworking and Hardware can be used to hold a workpiece while performing tasks like belt sanding, hand planing or scraping dried glue; multiple stops can “sandwich” a board to allow work in different directions without moving the board or stops. Although specifically designed to work with Rockler’s T-Track, the T-Track Stops will work with any T-Track that accepts 5/16″ bolts. They have a profile of less than 3/4″ when secured on the table. Each stop is made of machined aluminum and features a handle which is used to tighten the stop in place in its upright position, then flips down to be out of the way. The T-Track Stop are available in three varieties: short, in-line and long. The short and in-line stops are 1-1/2″ wide; the long stops 5″ wide. The short (item 47482) and in-line (item 43807) stops sell for $6.99 apiece, and the long (item 46010) stops for $12.99 each.