Reader Submitted

The Right Finish for the Right Job?

Rob Johnstone and Michael Dresdner answer a difficult question about when to use which finish?

by Reader Submitted • Apr 23, 2002 • Q & A
How to Tell If Your Vacuum Is Grounded?

A woodworker wonders whether or not his vacuum should be grounded.

by Reader Submitted • Apr 23, 2002 • Q & A
Little Bubbles or Bumps in Finish

Searching for the cause and correction of bumps in your finish.

by Reader Submitted • Apr 23, 2002 • Q & A
Glue Dries Too Fast

If you’re in a hot dry shop, your glue might be hard to maneuver without it drying.

by Reader Submitted • Apr 23, 2002 • Q & A
Dry Glue Is Gumming Up Sandpaper

Can you sand after gluing without ruining your paper?

by Reader Submitted • Apr 23, 2002 • Q & A
How Do You Use the Internet?

Here is a sampling of the comments we recieved on how readers use the internet in conjunction with their woodworking.

by Reader Submitted • Apr 23, 2002 • Not yet categorized
How to Trim an Un-Square Corner

How do you figure out the angle to cut your baseboards?

by Reader Submitted • Apr 9, 2002 • Q & A
How to Rewire a Motor

A reader reaches out to our experts for help reversing the direction of one of his motors.

by Reader Submitted • Apr 9, 2002 • Q & A
Polyurethane Finish Turning Yellow?

What causes the yellowing of poly finishes?

by Reader Submitted • Apr 9, 2002 • Q & A
Made in the USA?

Readers respond to past issue Q&A questions and offer another story of gifting woodworking projects.

by Reader Submitted • Apr 9, 2002 • Feedback