Reader Submitted
-
Fixing a Hole in Butcher Block?
I have a butcher block table that my ex drilled on, leaving a hole on the top. How can I repair?
-
Best Way to Paint Over Poly?
I have a china cabinet I would like to paint. Is there a primer I can use to paint over a poly finish, without sanding?
-
Less Lean on a Rocker; a Woodworker’s Project List; Shop Heating
In last issue’s Q&A, we had a reader who asked about fixing the lean on a rocking chair. Here are some additional suggestions along those lines from our readers.
-
Toy Spaceship
I built this toy spaceship for my grandson Aiden. It has a wooden frame covered with masonite.
-
Standing Writing Desk
Made from knotty alder and walnut from Peru. I’ve finally “retired” and can get back to my hobby and love of woodworking!
-
Turntable Case
A friend of mine picked up a vintage 1960s Empire 208 turntable. I restored it for him and set it up with a new cartridge.
-
How Can I Cut Plywood Squares Diagonally, Safely?
How can I safely cut the 12″ x 12″ from corner to corner to get two right angle supports?
-
Small Time Planing
When I want a real smooth finish instead of using steel wool and having all the steel dust to contend with I take a single edge razor blade and “plane” the fulling cured Poly coat with it.
-
Making Pen Holes Easily
I turn pens for fun, but drilling the hole in the blank was always a hassle.
-
Cooling Your Drill
After the first few holes, the heat buildup is great enough that there is the possibility of burning both the bit and the stock.
