Reader Submitted

Determining Fastener Length

Is there a rule of thumb for determining how long a fastener needs to be for the joint of a project?

by Reader Submitted • Jul 17, 2007 • Q & A
CompuCarve

Our tool preview in issue 176 was about the Sears CompuCarve, and it generated a good bit of comment, starting with complaints about what we did not do.

by Reader Submitted • Jul 17, 2007 • Feedback
Using the Twin Tenon

At what width would you suggest a twin tenon becomes advisable?

by Reader Submitted • Jun 19, 2007 • Q & A
Priming OSB

What can I use to prime OSB so I can paint it without loosening the outer flakes?

by Reader Submitted • Jun 19, 2007 • Q & A
Oils on Cedar

I read that the oils in cedar will break down both water- and oil- based finishes. Is this true?

by Reader Submitted • Jun 19, 2007 • Q & A
Drill Press Vibration

I tried brute force and cleaning the taper with paint thinner, but the chuck falls off my new drill press with any vibration. What can I do?

by Reader Submitted • Jun 19, 2007 • Q & A
Of Cutting…Boards?

n the last issue, we asked you woodworkers whether you were loyal to wood cutting boards or partial to plastic. In some homes, it seems the dishwasher influences the decision.

by Reader Submitted • Jun 19, 2007 • Feedback
Separating Two Stuck Pieces of Wood

I put two-sided tape between two pieces of wood to cut them out together. Now I can’t get them apart. Any suggestions?

by Reader Submitted • Jun 5, 2007 • Q & A
I Have Tremors in My Right Hand

I have tremors in my right hand. A few years ago, a company made scales with slots in them, which would help. Are they still in business?

by Reader Submitted • Jun 5, 2007 • Q & A
Exterior Polyurethane Finish without Discoloration

Is there an exterior polyurethane that does not impart the amber color to wood?

by Reader Submitted • Jun 5, 2007 • Q & A