Reader Submitted

Grid Pattern Schematic

What is the best way to transfer a grid pattern from a schematic to the stock?

by Reader Submitted • Nov 8, 2005 • Q & A
5 HP Shop Vacuum

Is there enough suction from a 5 HP shop vacuum to remove the air from a large vacuum press bag?

by Reader Submitted • Nov 8, 2005 • Q & A
More Hints on Flooded Tools

Readers voice their opinions on headphones in the shop and tell tales of attempting to salvage flooded tools.

by Reader Submitted • Nov 8, 2005 • Feedback
Sharpening a Curved Draw Knife?

Employing a sandpaper sharpening system, a slip stone, or a bench grinder are some of the methods suggested for sharpening a curved draw knife.

by Reader Submitted • Oct 25, 2005 • Q & A
Source of Pressure-Treated Wood

Is pressure treated wood made from white pine or yellow pine?

by Reader Submitted • Oct 25, 2005 • Q & A
Chair Seat Top Explained

How is a chair seat’s top formed? Is it sanded into shape, or is there a different way to contour the wood?

by Reader Submitted • Oct 25, 2005 • Q & A
Applying Spray Finishing

I want to spray finish, but I have heard that it is not a good thing to use thin varnishes before applying. Is that true?

by Reader Submitted • Oct 25, 2005 • Q & A
Before and After; What and How

A question in the last issue about which finishes are safe for cribs sparked this reminiscence from a reader.

by Reader Submitted • Oct 25, 2005 • Feedback
Tubular Bed Plans

Do you have any knowledge of DIY plans to make a steady test for a tubular bed for a woodturning lathe?

by Reader Submitted • Oct 11, 2005 • Q & A
Shim and Spacer Supplies

Michael Dresdner acquiants one reader with a variety of resources for buying shims and spacers.

by Reader Submitted • Oct 11, 2005 • Q & A