Reader Submitted
-
Shunned at the Lumberyard
Readers share the stories of their experiences, good and bad, at the lumberyard.
-
Taking Another Pass at Joining
Reader comment on rabbet cuts, planers in a beginner’s shop, and the Drill Doctor Pro.
-
Back from the Ashes
Can anyone suggest a method of returning heated and smoked wood to its original color and getting rid of the strong smoke odor?
-
Equipment or Design Failure?
My first cut worked great, but subsequent attempts pushed the 3/8″ saw blade “out” of track. Changing to new blade got the same result. What am I doing wrong?
-
Non-sanding Solution to Blade Burn?
Other than sanding, is there any other way to remove burn marks caused by a table saw blade? I use a Forrest blade and still get burn marks on oak.
-
Shunned at the Lumberyard
The last visit to a lumberyard I asked for the 1/4″ maple veneer plywood I need for cabinet doors for my kitchen. I was answered with, ‘we don’t have it and you can’t get it.’
-
Setting Maximum Tenon Width
When mating wide boards with mortise and tenon joints, what is a good rule of thumb to use for the maximum width of the tenon, or at least, the maximum width to which glue should be applied?
-
Finding Substitutes for Naphtha
Could you please explain what naphtha is, and has it got any other names? I live in Australia and have not found a source for naphtha. What is the closest substitute?
-
Rabbeting an Edge with a Jointer?
I just got my first jointer, a General 6″. But for the life of me, I can’t figure out how to use the rabbet edge on the outfeed table. Can you help?
-
Toxic Tropical Wood?
I know that there are concerns about refinishing certain tropical woods due to the oil content. Is there anything special that I need to know about refinishing koa wood furniture?
